| Tensorgrip TC42 SUPER STRENGTH INFUSION RTM ADHESIVE 产品介绍 |
||
|---|---|---|
| 产品型号(Product model) | Tensorgrip TC42 | |
| 产品图片(Product Picture) |  |
|
| 产品简介(Product Introduction) | Tensorgrip® TC42专为灌注模具市场而设计 。 本产品是一种高性能溶剂型聚合物黏合剂，探用加压槽输送系统。Tensorgrip®TC42 专门设计用于在树脂灌注过程中将增强纤维固定到位，而不影响表面光洁度或结构完整性。它与聚酯、苯乙烯和乙烯基酯树脂相容 。 该黏合剂还成功通过了环氧树脂测试，每平方公尺使用的黏合剂少于 9克。 | Tensorgrip® TC42 is designed for the infusion mold market. This product is a high-performance solvent-based polymer binder, and is used for detection pressurized tank conveying system. Tensorgrip®TC42 is specially designed to hold reinforcing fibers in place during resin infusion without affecting surface finish or structural integrity. It is compatible with polyester, styrene and vinyl ester resins. The binder also successfully passed the epoxy resin test, using less than 9 grams of binder per square meter. |
| 优点(Product Advantages) |
|
|
| 应用于(Product application in) |
|
|
| 喷涂面(Spraying surface) | 1面 | 1 side |
| 开放时间(Opening hours) | 10分钟 | 10 minutes |
| 干燥时间(Drying time) | 1-2分钟 | 1-2 minutes |
| 耐温(Temperature resistance) | ||
| 可覆盖面积(平米) Coverable area (square meter) |
小瓶500ML，4平方米左右粘合覆盖层或8平方米单面覆盖层 大罐22L，约170平方米粘合覆盖或340平方米单面 |
Small bottle 500ML, adhesive cover layer about 4 square meters or single-sided cover layer or 8 square meters Large jar 22L, approximately 170 square meters or single-sided cover layer or 340 square meters |
